Overview

The MG995 Servo Motor is an all metal gear servo motor operating on a wide voltage range of 4.8V to 6.6V DC, it offers exceptional torque of 11 kg/cm, ensuring performance in various applications. Its swift reaction speed (no load speed of 0.20 seconds / 60 degrees at 4.8V and 0.16 seconds / 60 degrees at 6.0V. make it a preferred choice for many applications like Robots, Robotic Arms, RC plane, RC car etc.

Dimensions

A	B	C	D	E	F
42.7	40.9	37	20	54	26.8
Unit: Milimetre (mm)

Specifications

Voltage	4.8V to 6.6V DC
Torque	9.4 kg/cm at 4.8V 11 kg/cm at 6.0V
Speed	0.20 seconds / 60 degrees at 4.8V 0.16 seconds / 60 degrees at 6.0V
Current	10 mA (Idle Current) 170 mA (No Load Current) 1200 mA (Stall Current)
Gear Type	Metal
Cable Length	30 cm
Plug / Connector	JR FUTABA Universal
Operating Temperature	0°C to 55°C
Weight	55g

Pinout

Servo motor pinout and wire color coding.

No.	Pins	Color
1	Signal	Yellow
2	VCC	Red
3	GND	Brown

Connections & Code

Connection

Signal: Connect to pin D9
VCC: You may connect this to 5V pin on arduino UNO but we recommend to connect it to an external power supply between 4.8V to 6.6V DC.
GND: Connect to GND. Make sure you connect all ground pins together. If you are using an external power supply connect the power supply ground to aduino UNO GND.

Code

Before we move into coding, first we need to install the Servo library written by Michael Margolis, Arduino in the Arduino IDE.

You can install this library by directly going to Tools > Manage Libraries which opens the Library Manager. In the library manager search for Servo using the search bar and click on the install button to install the latest version of the Servo library.

/* Sweep*/

#include <Servo.h>

Servo myservo;  // create servo object to control a servo
// twelve servo objects can be created on most boards

int pos = 0;    // variable to store the servo position

void setup() {
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
}

void loop() {
  for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
    // in steps of 1 degree
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15 ms for the servo to reach the position
  }
  for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15 ms for the servo to reach the position
  }
}